“5.3 No fittings, other than those approved, may be attached to, or carried on the inside or outside, of the vehicle. 5.4 No modification may be carried out to a taxi without the prior approval from the PCO. Before considering any unapproved modification to a taxi, approval must be sought from the PCO. …. 13. New taxi models must meet the current and relevant EC Directive for exhaust emissions, i.e. the respective Euro standard. Current taxi models must meet prescribed emissions standards (currently Euro 3 for NOx and PM 10 by July 2008).”
“Lower NOx emissions are strongly correlated with reduced in-cylinder gas temperatures, and reduced reaction between nitrogen and oxygen. It is possible to reduce NOx emissions in other ways, but EGR is a popular, effective and relatively low cost method of securing reduced NOx emissions. I noted that all the emissions reduction systems approved by EST and subsequently offered for sale commercially following the early 2006 completion of approved trials used some form of EGR.”
“The PCO remains confident that all the approved reduction systems are fit for purpose and, if correctly fitted to properly prepared and maintained vehicles that have undergone the measures listed above, will deliver the required standard.”
“I would like to seek approval to test the Eco-Power emissions reduction system on the TX1 taxis. The system will be exactly the same as used in the Fairway system. The only slight modification is to reposition the EGR return pipe (as discussed at inspection).”
“I [Mr Stock] have been informed that you have subsequently sought to modify the current Eco-Power system by changing the catalyst for a slimmer version and also re-incorporating the vehicles original EGR valve. Please be advised that the authority above does not refer to the modified system and that you will be required to successfully undertake the appropriate emissions testing and durability trial before any further authority can be issued.”
“The points I need to raise about Dave Davies are that he turned up at the PCO yesterday 12-7-07 unannounced and brought with him T441 AGU for Randal to inspect. Dave Davies informed Randal, and showed him, that he had changed the catalyst for a modified slimmer version and also reincorporated the vehicle original EGR valve albeit that the systems cooled EGR circuit remained in position. Dave Davies then informed Randal that he would be testing this next week.”
“Dave Davies is under no illusions that he can modify the system and get away with doing a durability trial. Seemingly, he wants an approval for the identical system first and then wants to develop a newer, modified system which will have to undergo the durability trial and further emissions testing.”
“I would also like to give you some more details about the modified TX1 Euro 2 system which was inspected by yourselves last week. This system will be called the Eco-Cat system. It is very similar to the previous system but will have the following modifications. 1. It uses the same EGR diesel/exhaust heat exchange system but with the recirculation being directly back into the exhaust system instead of back to the air intake. This will have the benefit of slightly heating the diesel to make it burn more efficiently and slightly reducing the emissions tailpipe temperature. 2. It will utilize the taxis existing EGR system (which was blanked off for the previous system). 3. It uses a similar configuration of a Diesel Oxidation Cat (DOC) in conjunction with 2 back to back Diesel Particulate Filters. The unit is supplied by a UK manufacturer…. As soon as we have emissions test results (being carried out this week) I will update you further and will request a further inspection to allow us to commence the durability testing.”
“For our records could you please give a breakdown of your system (2 pager or so) using the following headings Type of System - (schematic etc) Components System Function Required Maintenance Fitting Time.”
“Please find attached a basic drawing of the system and a parts list. Fitting time is about 2 hours. Please let me know if you need any more info.”
“Having analysed the schematic diagram I formed the view that what Mr Davies was now seeking approval for was a system which appeared similar in all respects to that which had been approved before, save that it had a different filter. On that basis and that basis alone, I formed the view that it was not necessary for EST personnel to supervise the emissions testing. The system which I understood was being proposed was one which, from an engineering perspective, could be expected to work.”
“This system is a development of Eco-Power’s previous TX1 Euro 2 approval and now uses an Emitec rather than DCL partial filter.”
“… [W]e would ask that you arrange all of the following: • Install the EGR system on taxi V505 LMX as per original schematic supplied to EST (EGR to intake manifold) • Install replacement or reconditioned injectors on taxi V505 LMX • Forward a written report to the PCO detailing the faults found and the actions taken to rectify these faults within 28 days of this letter. Emissions results from a VCA approved test laboratory, the test to be witnessed, should be supplied as proof of rectification. • Supply the PCO with registration numbers of all taxis fitted with this non-conforming system and a plan of action to rectify taxis that are in service with this system.”
“Thank you in advance for your cooperation with this matter. Please do not hesitate to contact me should you have any concerns.”
“It is imperative that you comply with the requirements listed above in order to avoid my considering the authority for the installation and use of Eco-Power system and draw you [sic] attention to paragraph three of my letter dated13 June 2003 .”
“The inspection also revealed that the injectors had not been changed recently. I would like to remind you that it is one of the EST certification conditions that the injectors are removed for cleaning or replacement as part of the process of fitting the exhaust after treatment system. This is also one of the specifically mentioned requirements in the “Fitment declaration Sign-Off” sheets as set out in PCO Notice 54/06 issued on15 November 2006 and supplied to you at the point your system was first approved by this office.”
“If you require us to carry out further work and testing can you please make a formal request to the taxi owner to take possession of the taxi.”
“…that a system which was being sold in substantial numbers to taxi drivers appeared (a) not to work and (b) not to conform to the approval which I had granted. I had to bear in mind that the longer the situation was allowed to continue the longer taxi drivers would potentially be prejudiced by buying a system which they would in due course have to replace. That is why I acted as a matter of urgency.”
“This letter is further to my letter dated18 February 2008 regarding a conformity inspection conducted by [EST] on taxicab registration V505 LMX that was fitted with the Eco-Power emissions reduction equipment and the subsequent further detailed Emissions Conformity Testing. In this letter I have you the opportunity to comply with a list of requirements within 28 days of the letter of the letter. To date there is no record of any action having been taken to remedy the shortcomings of the Eco-Power system fitted to taxi registration V505 LMX. [EST] has advised me that following careful consideration of a number of aspects of the exhaust after treatment system supplied by Eco-Power for fitment to Euro 2 LTi TX1 taxi models, they have recommended that Eco-Power should be removed from the list of companies eligible to supply exhaust after treatment systems for taxis in support of the Mayor’s Taxi Emission Strategy. In the light of this recommendation it is with immediate effect that I withdraw authority for the installation and use of any further Eco-Power emission reduction systems. A PCO Notice has been issued to this effect. Please instruct all of your appointed installation agents that as of today, any further systems supplied by Eco-Power shall not be recognised or accepted as complying with EST requirements. If you wish to challenge the EST recommendation and the PCO’s subsequent withdrawal of approval, you should do so in writing to the Accreditation manager, transport at [EST].”
“Pictures relate to inspection carried out one week after inspection carried out on 12-67-07”
“Reference email dated 13-07-07 from Dave Stock to Finn Coyle. Ref 9d. 9e.”
“The Claimant submits that it had a legitimate expectation to the entitlement to sell its modified system, and that the decision to withdraw approval unlawfully defeated this expectation.”